• Открыт набор модераторов на нашем форуме. Заявку можно подать в разделе "Вопросы и предложения" > "Набор модераторов".

G38.2-G38.3: Probe target

  • Просмотры Просмотры: 24
  • Последнее обновление Последнее обновление:
  • Описание
    The Probe Target commands are used to probe towards a workpiece and determine its precise position. You might, for example, use a grounded metal workpiece, with a metal probe spliced into the bed probe circuit.
    • G38.2 probes towards a target and stops on contact, signaling an error if it reaches the target position without triggering the probe.
    • G38.3 probes towards a target and stops on contact. No error is given if it fails to trigger the probe.
    These commands use the current homing feedrate, by default.
    Примечание
    These commands require G38_PROBE_TARGET and a defined probe.
    Использование
    G38.2 [F<rate>] [X<pos>] [Y<pos>] [Z<pos>]
    Параметры
    [F<rate>]
    Feedrate for the move
    [X<pos>]
    Target X
    [Y<pos>]
    Target Y
    [Z<pos>]
    Target Z
  • Загрузка…