• Открыт набор модераторов на нашем форуме. Заявку можно подать в разделе "Вопросы и предложения" > "Набор модераторов".

M413: Power-loss Recovery

  • Просмотры Просмотры: 19
  • Последнее обновление Последнее обновление:
  • Описание
    Enable or disable the Power-loss Recovery feature. When this feature is enabled, the state of the current print job (SD card only) will be saved to a file on the SD card. If the machine crashes or a power outage occurs, the firmware will present an option to Resume the interrupted print job. In Marlin 2.0 the POWER_LOSS_RECOVERY option must be enabled.
    This feature operates without a power-loss detection circuit by writing to the recovery file periodically (e.g., once per layer), or if a POWER_LOSS_PIN is configured then it will write the recovery info only when a power-loss is detected. The latter option is preferred, since constant writing to the SD card can shorten its life, and the print will be resumed where it was interrupted rather than repeating the last layer. (Future implementations may allow use of the EEPROM or the on-board SD card.)
    Примечание
    Requires POWER_LOSS_RECOVERY and an LCD controller.
    Использование
    M413 [S<bool>]
    Параметры
    [S<bool>]
    Flag to enable or disable Power-loss Recovery. If omitted, the current enabled state will be reported.
    Примеры
    Enable power-loss recovery
    M413 S1
    Disable power-loss recovery
    M413 S0
    Report power-loss recovery state
    M413
    Power-loss recovery ON
  • Загрузка…